Skip to main content

This website uses technologies with which we collect information on your user behaviour (tracking and targeting). This is how we recognise you again the next time you visit the website. We use the information collected to make your visit to the website more pleasurable and personalised. Personalisation means that you will receive suitable product suggestions on this website, and on other sites, by way of advertising. We use the tracking data at the same time to continuously improve the quality of our advertising activities. For more detailed information in this respect, and on the technologies used, please consult our data protection declaration.

You can, of course, also use the website without consent being required for tracking and targeting. If you do not agree, the website does not collect any data on your personal user behaviour. Only one cookie will be stored in your browser, which will henceforth remind us that you do not want your user behaviour to be logged. Please confirm if you give your consent.

TECHNIPRO RV 700-14E

0000/3187 - TECHNIPRO RV 700-17E, single-cable outlet 14 dB - silver
TECHNIPRO RV 700-17E, single-cable outlet 14 dB
TECHNIPRO RV 700-17E, single-cable outlet 14 dB
In single-cable satellite reception systems, interferences are possible if individual subscribers or receivers block the trunk line by means of an 18 V constant signal. Due to these interferences, other subscribers are no longer able to communicate with the multi-switch or LNB.
In practice, it is also possible that incorrectly configured receivers use the user IDs of other subscribers. In this case, we are talking about interferences in the form of the so-called ping-pong effect, because two subscribers “fight“ for the same transponder.
The single-cable outlets of the RV 700-E series have a microcontroller that monitors signalling inside single-cable systems. In addition to signal voltages (14 V/18 V), audio signals (22 kHz) or DiSEqCTM signals are also analysed.
The antenna outlets turn off a permanent voltage of 18 V and, by means of a user ID check, ensure that only the enabled user band IDs are transmitted from the receiver to the multi-switch via the outlet.
The PROGRAMMING UNIT RVP 700 transmits the user band IDs which need to be enabled to the single-cable antenna outlet, thus ensuring that the subscribers in a single-cable antenna system do not interfere with each other.
Using the PROGRAMMING UNIT RVP 700, a specialist retailer or installer configures one or several defined user IDs in the single-cable antenna outlet during the installation of the antenna system. To do so, the specialist retailer or installer connects the programming device to the F-socket of the antenna outlet. By means of the TechniSat RVcontrol app, a connection to the PROGRAMMING UNIT is established, and the data for the configuration
of the antenna outlet is transmitted to the programming device.

Technical Data

Article information

4019588031876
0000/3187
silver

Connector type

IEC connector (f)
IEC connector (m)
F-socket

frequency range

87.5 ... 108 MHz
950 ... 2150 MHz
5...68/ 118 ... 862 MHz

Shielding factor

≥ 85 dB
≥ 80 dB
≥ 75 dB
≥ 55 dB

Tap loss

15 dB
14 dB
14 dB

Transmission loss

1.1 dB
1.1 dB
1.9 dB