This website uses cookies. If you use this website, please agree to the use of cookies. We do not collect any data that can be used to identify you personally. You can find more detailed information in our data protection declaration / Imprint.

OK

[ x ]

TECHNIPRO RV 700-10E

0000/3186 - single-cable outlet 10 dB - silver
TECHNIPRO RV 700-10E, single-cable outlet 10 dB
TECHNIPRO RV 700-10E, single-cable outlet 10 dB
In single-cable satellite reception systems, interferences are possible if individual subscribers or receivers block the trunk line by means of an 18 V constant signal. Due to these interferences, other subscribers are no longer able to communicate with the multi-switch or LNB.
In practice, it is also possible that incorrectly configured receivers use the user IDs of other subscribers. In this case, we are talking about interferences in the form of the so-called ping-pong effect, because two subscribers “fight“ for the same transponder.
The single-cable outlets of the RV 700-E series have a microcontroller that monitors signalling inside single-cable systems. In addition to signal voltages (14 V/18 V), audio signals (22 kHz) or DiSEqCTM signals are also analysed.
The antenna outlets turn off a permanent voltage of 18 V and, by means of a user ID check, ensure that only the enabled user band IDs are transmitted from the receiver to the multi-switch via the outlet.
The PROGRAMMING UNIT RVP 700 transmits the user band IDs which need to be enabled to the single-cable antenna outlet, thus ensuring that the subscribers in a single-cable antenna system do not interfere with each other.
Using the PROGRAMMING UNIT RVP 700, a specialist retailer or installer configures one or several defined user IDs in the single-cable antenna outlet during the installation of the antenna system. To do so, the specialist retailer or installer connects the programming device to the F-socket of the antenna outlet. By means of the TechniSat RVcontrol app, a connection to the PROGRAMMING UNIT is established, and the data for the configuration
of the antenna outlet is transmitted to the programming device.

Technical Data

Article information

4019588031869
0000/3186
100 g
7.00 x 7.00 x 2.50 cm
silver

Connector type

IEC connector (f)
IEC connector (m)
F-socket

frequency range

87.5 ... 108 MHz
950 ... 2150 MHz
5...68/ 118 ... 862 MHz

Shielding factor

≥ 85 dB
≥ 80 dB
≥ 75 dB
≥ 55 dB

Tap loss

11 dB
10 dB
10 dB

Transmission loss

1.1 dB
1.1 dB
1.9 dB

Additional products

PROGRAMMIERADAPTER RVP 700 (for RV 700-E series)

PROGRAMMIERADAPTER RVP 700 (for RV 700-E series)

Programmer for singel-cable outlets

UNYSAT 24TN-LNB

UNYSAT 24TN-LNB

SCR-LNB for 24 participants

TECHNIROUTER 5/1x16

TECHNIROUTER 5/1x16

Digital single-cablesolution for the distribution of satellite signals from one orbital position via a cable harness for an existing cable structure

TECHNIROUTER 5/2x16

TECHNIROUTER 5/2x16

Digital single-cablesolution for the distribution of satellite signals from one orbital position via a cable harness for an existing cable structure